Installation Instructions on a Cabinet Mounted Toaster Oven

These commands are primarily based off of the Black and Decker SpaceMaker toaster oven. A exceptional logo might vary a bit on the way to install.

First, unpack mounting washers, screws and spacers for mounting, ensuring the whole lot is there, and set them aside in a secure place where they will no vesa 200×200 longer roll away or get lost. There is a sample paper blanketed this is called a template.

When you choose the area, make sure it’s far within reach of an electrical outlet. The twine supplied is a short cord. Don’t mount over some other heating or cooking appliances nor over the sink. Do no longer put it below, in front of, or at the back of any below cupboard lighting. And also, make sure it’s miles at least four inches far from any partitions or surfaces.

To begin you want to determine if your cabinet has a flat backside or an overhang. Put your hand underneath the cabinet and feel if the bottom is flush with the the front of the cabinet or when you have to reach up to the touch the bottom.

The hood/deflector of the toaster oven is detachable to make set up simpler. Remove it by using pulling forward barely on the hood to release the the front hooks. Once the front hooks have released, the hooks at the rear will disengage effortlessly.
Drilling.

1. Open cabinets and dispose of contents to make mounting less difficult.

2. Position the mounting template on the bottom of your cupboard, ensuring to align thick line on template with the front edge of your cabinet, taping securely. Check that the screw holes might not line up with the dividing partition within the cupboard.

If the cupboard has an overhang, degree the depth or thickness of it and discover the dashed line on the template that has the identical degree. This is the road to use for that cupboard, aligning with the the front and carefully bending it around at the overhang, taping as you try this. Continue to keep it against the cupboard and end positioning it and taping in location.

3. Drilling from below the cabinet up, drill holes via the 4 places marked on the template, the usage of a ¼-inch drill bit making sure to drill immediately up thru the mark at the template and now not at an attitude. SAFETY TIP: Wear safety glasses.

4. After the holes are drilled, cautiously dispose of the mounting template if you pass or want to remount at a later time.

5. Clean up dust and debris within the cupboard and the bottom below.

6. Place washing machine within the cabinet over each of the 4 holes you drilled.

7. Hold hood in region, aligning front of hood with front fringe of cabinet; drilled holes on cabinet must be aligned with mounting holes at the hood.

Eight. Insert the screws down via the holes inside the cupboard, tightening in area to secure hood to cupboard. If the cabinet has an overhang, degree the space as much as the lowest of the cupboard and use the wide variety of spacers had to identical that distance. For example, if the overhang measures 1″ up to the lowest of the cupboard, then two ½ inch spacers are needed on each screw to preserve the toaster oven established stage or even.

Note: Always tighten screws to make certain the appliance does no longer circulate or shake during operation.

Once the hood is secured, lift the toaster oven up, enticing the rear hooks on the hood first, and then the front. Any extra wire may be hung over the cord management hook at the back of the unit.

If you’re doing the spacer set up, you will probable want someone to help preserve spacers in vicinity even as putting the hood. A couple of clamps might be capable of be used on the ones within the the front if there is not all of us to help. Short of getting clamps or a person to help, perhaps you may consider something innovative to clear up that.